Rachel Auto

12V 100A Flashing Power Supply and 100A HD Battery Charger

$0.00

SOLAR 12V 100A Flashing Power Supply and 100A HD Battery Charger

  • 0-100A (on demand) power supply mode to maintain system voltage
  • Properly charges Flooded, AGM, Spiral Wound, Deep Cycle and Marine Batteries
  • Forced start mode allows charging of totally dead batteries
  • Battery repair mode overcomes battery sulfation to restore reserve capacity
  • Reverse polarity protection and battery fault detection
  • Extra-long 13′ cable reach
  • PowerJaw clamps provide improved access to hard-to-reach batteries
  • PowerJaw clamps allow the hood to be closed (most vehicles) during ADAS calibration
  • Requires 20A service
  • Power supply mode provides optimal support for vehicle reprogramming and ADAS recalibration
  • Power supply mode has minimal voltage ripple (<100mV)
  • Power supply mode features Rapid Load Response (RLR) technology
  • 100/40/10A charging modes allow quick, efficient charging of all battery sizes
UGS : BDBV-PL6800 Catégorie :

The PL6800 is designed to provide stable power, on demand up to 100 amps, to a vehicle electrical system to support module reprogramming. It is also designed specifically for fleet service battery charging with a maximum charge rate of 100 amps, to quickly and effectively bring 4and 8-battery Group 31 packs back to full charge. In power supply mode, the PRO-LOGIX PL6800 provides power to maintain vehicle electrical system voltage at a preset level, increasing its output in response to system load increases to maintain a stable power environment for successfully reprogramming. It features a voltage output range of 13.1-14.9V, adjustable in 0.1V increments. allowing the operator to dial the output in exactly as specified by the supplier of the vehicle under service. It features fast load responsiveness for ultra-quick recovery from system demand increases. It also delivers its massive power with minimal voltage ripple (<100mV), providing a clean flow of power to the vehicle without risk of programming interference. In charging mode, the PL6800 utilizes advanced microprocessor-controlled logic to precisely deliver a fully automatic charging routine designed to optimally charge and maintain each battery or battery pack serviced. The PL6800 features the ability to properly charge a wide variety of lead acid battery types, including Conventional, AGM, Spiral Wound, Start-Stop, Deep Cycle and Marine batteries ? for virtually any lead acid battery type installed in a vehicle, the PL6100 can deliver a proper, beneficial charge. The PL6800 adapts its charging approach based on the needs of each battery or battery pack it services. Such adaptations can include activating a soft start mode on deeply discharged batteries, a battery repair mode on older/distressed batteries and temperature compensation when charging in extreme temperatures. It also incorporates numerous features to make charging safer for the operator and the vehicle/battery being charged.

Additional Attributes:

GTIN: 00010271026968
AC Input: Requires 20A service
Add-On: N/A
Battery Fault Detection: Yes
Battery Types Charged: Flooded, AGM, Spiral, Deep Cycle, Marine
Charging Phases: 7
Charging Rates: 100/40/10A
Maximum Voltage Ripple in PS Mode: 100mV
Operating Voltage: 12V
Operational Mode: Automatic
Output cable Gauge: #2AWG
Output Cable Length: 13′
Power Supply Output: 0-100A on Demand, 13.1-14.9V
Prop 65 (C, R or CR): C
Prop 65 – Long Label: Warning – Both Cancer and Reproduction.JPG
Prop 65 – Short Label: WARNING: Cancer – www.p65warnings.ca.gov
Prop 65 Warning Chemical Listing: Vinyl Chloride, Styrene, Acrylonitrile,
Prop 65 Yes/No: Y
Reverse Polarity Protection: Yes
Temperature Compensation: Yes
UPC: 10271026968
Warranty: 1 Year Limited
Weight: 25 lbs.
WS1: 1 Year Limited
WS2: TX

Extended Information:

Emissions : Emissions Compliance Exempt
Life Cycle Status: Discontinued

Packaging:

Quantity of Each: 1
Package UOM: EA
Dimension: 17 x 12 x 10 inches
Weight: 25 PG

Poids11.34 kg
Dimensions17 × 12 × 10 cm